Cabot's Interior Stain Oil Based rejuvenates and transforms the colour of interior timber doors, windows, trim and furniture. It must be over coated with Cabot's Cabothane Clear Oil Based or Cabot’s Danish Oil to give the protection and durability required on interior timber.
Touch Dry
2 hours
Application Tools
Brush, Roller, Other
Do not apply this product if the temperature is below 10°C or above 35°C.
Note: Fill nail holes, cracks and other defects with Cabot&rsquo ; s Wood Tone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable floor polish remover.
Bare timber
Sand the surface smooth using 180 - 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust.
Previously coated timber
Completely remove the previous coating using a paint stripper or by sanding. Remove all traces of sanding dust.
Important
The natural colour of the timber will affect the finished colour of the stain. The clear coating used to seal the stain may also have some affect on the final colour. Always test the stain on an off cut or concealed part of the actual job before proceeding.
Staining a floor
For the best method of staining a floor, please refer to the Cabot's Stain & Varnish range.
Roller, Brush, Rag
Stir thoroughly with a broad flat paddle until pigment is mixed in and colour is uniform.
Keep well stirred during use. If using more than one can, mix all cans together into a larger container to ensure colour uniformity.
Apply with a good quality brush, roller or lint free rag and work the stain evenly into the grain.
Allow to set for 2-10 minutes then rub with a clean soft cloth using a circular motion to remove any excess stain and produce an even coloured surface. The intensity of the colour will depend on porosity of timber and the length of time before the stain is wiped off. Allow 8 hours drying time.
Apply Cabot's Cabothane Clear Oil Based or Cabot's Danish Oil as a top coat following label instructions.
Maintenance
Regular inspection of all coated surfaces is recommended.
