Intergrain UltraDeck® Timber Stain is a long lasting, high performance water based staindesigned to transform the colour of exterior timber. The enduring finish guards timber againstharsh weather conditions as well as the abrasive effects of foot traffic, providing your timbersuperior protection for longer.Intergrain UltraDeck Timber Stain is a semi-transparent finish, meaning the colour, age andcondition of the timber to be stained will impact the final colour and finish. Because of this, anyrepresentation of Intergrain UltraDeck Timber Stain colour is to be viewed as a closerepresentation of the colour that can be achieved. Always test on a small area or off-cut forcolour suitability before use. The instructions below offer general preparation and applicationguidelines for exterior timber. For larger projects, cladding, interior, commercial jobs or formore specific information please contact our Help & Advice team.
Cleaning materials
Water
Application Tools
Brush, Pad, Spray
# Coat in any season limitations
Do not apply if:
Humidity is higher than 85%
Air or surface temperatures are above 35°C or below 5°C
Rain or dew is expected before coating is rain ready ^
Doing so may result in difficult application, poor adhesion and blistering.
Grey and weathered with no previous coating
Clean with Intergrain UltraPrep Timber Cleaner. For severely weathered timber, sand back to a fresh surface, remove all sanding dust, then clean with Intergrain UltraPrep Timber Cleaner.
New timber
Treat timber with Intergrain UltraPrep Tannin & Oil Remover. Then clean with Intergrain UltraPrep Timber Cleaner.
Remove excess water from the surface and allow the timber to dry for at least 1 hour before coating.
Stir Intergrain UltraDeck Timber Stain thoroughly before and during use with a flat blade stirrer.
It is recommended to test in a small area to ensure satisfaction with the colour and finish prior to staining the whole project, ensure to apply 2-3 coats for the best indication of final colour.
Apply Intergrain UltraDeck Timber Stain using the Intergrain DeckBrush (recommended), flat deck applicator, paint brush or spray (air assisted airless or airless). Do not use a roller.
Apply at the coverage rate of 6-12m2/L. Do not overspread or apply thinly as insufficient film thickness will result in lap marks and compromise performance and durability. When coating large areas, work in sections, apply long strokes and use natural breaks in the boards as stopping points. If spraying, it is recommended to back brush to even out the finish and avoid spotting.
Allow to dry following the recoat time indicated in the section TYPICAL PROPERTIES above, then apply a second coat. If necessary, sand lightly between coats to remove any raised grain.
A third coat will give extra protection and is required in harsh conditions such as full sun exposure, around pools and in humid areas or if the first coat was applied on damp or porous timber.
Important: All timber is required to be free from dust, mould and site contaminants prior to coating. Follow all relevant product label instructions when using Intergrain products. Keep freshly coated contacting surfaces such as doors and windows ajar for several days to prevent sticking.
Maintenance
Conduct a routine 12 monthly maintenance inspection. Colour fade is the first sign of need to recoat.
Best protection of the timber and ease of maintenance is ensured if Intergrain UltraDeck Timber Stain is recoated before deterioration of the coating and timber underneath occurs.
