Cabot's Garden Furniture Oil Water Based is a highly durable, low odour exterior oil. It isdesigned to provide exceptional durability to garden furniture, BBQ trolleys and benches andlasts longer than traditional garden furniture oils. Garden Furniture Oil Water Based's advanceddual technology allows natural oils to penetrate and nourish the timber, then creates a durableacrylic barrier for a beautiful natural finish.
Re-coat
2 Hours
Cleaning materials
Water
Application Tools
Brush
Do not apply this product in temperatures below 10°C or above 35°C, or when rain or heavy dew is expected during the drying period. In hot temperatures do not apply in direct sunlight, cool the timber by lightly dampening with water and coat in the shade.
Note fill holes and imperfections with a suitable timber putty.
Previously painted or varnished timber
Remove back to bare timber using a paint stripper, or sanding. For exterior surfaces clean with Cabot’ s Deck Clean following label instructions.
Previously stained or oiled timber
For exterior surfaces clean with Cabot’ s Deck Clean following label instructions, then allow timber to fully dry. Test if the surface is ready for coating by sprinkling water on the timber. If the water beads on the surface, repeat the application of Cabot’s Deck Clean. If water is absorbed into timber, it is ready for coating. For a more transparent look, sand timber back to bare before coating.
Weathered and grey timber
For best results, sand timber back to fresh substrate. Clean with Cabot’ s Deck Clean following label instructions.
Bare timber
To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions.
Stir thoroughly with a broad flat paddle before and during use. Apply liberally along the length of the timber including exposed edges and end grain, by brush. The initial milky colour helps with even product application, drying to a semi-transparent finish. Apply two coats allowing 2 hours between coats.
Maintenance
Re-apply as the timber changes colour or when water repellency diminishes due to weathering. Follow surface preparation instructions.
