Cabot’s Water Based Deck & Exterior Stain (Colour Control formula) is a highly durabledecking stain for all exterior timber and decks that lasts longer than traditional decking stains. Itis ideal to enhance the look of timbers such as treated pine and rejuvenate worn timbers. It'sadvanced dual technology allows natural oils to penetrate and nourish the timber, then createsa durable acrylic barrier for extra protection.
Touch Dry
1 Hour
Re-coat
2 Hours
Cleaning materials
Water
Application Tools
Brush, Pad
Do not apply this product in temperatures below 10 degrees Celsius or above 35 degrees Celsius, or when rain or heavy dew is expected during the drying period. In hot temperatures do not apply in direct sunlight, cool the timber by lightly dampening with water and coat in the shade.
Note fill holes and imperfections with a suitable timber putty if required.
Previously painted or varnished timber
Remove back to bare timber using a paint stripper, or sanding. For exterior surfaces, clean with Cabot's Deck Clean following label instructions.
Previously stained or oiled timber
For exterior surfaces, clean with Cabot's Deck Clean following label instructions, then allow timber to fully dry. Test if the surface is ready for coating by sprinkling water on the timber. It the water beads on the surface, repeat the application of Cabot's Deck Clean. If water is absorbed into timber, it is ready for coating. For a more transparent look, sand timber back to bare then clean with Cabot's Deck Clean before coating.
Weathered and grey timber
For best results, sand timber back to fresh substrate. Clean with Cabot's Deck Clean following label instructions.
Bare timber
To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions.
Stir thoroughly with a broad flat paddle before and during use. Apply liberally along the length of the board including exposed edges and end grain using a brush or pad applicator. The initial milky colour helps with even product application, drying to a semi-transparent finish. Allow the first coat to dry and then apply a second coat using the same method. Continue applying coats until you achieve the depth of colour you desire.
Maintenance
Re-apply as the timber changes colour or when water repellency diminishes due to weathering. Follow surface preparation instructions. To achieve a deeper colour or more opaque finish, further coats can be applied.
