Dulux Metalshield® RFU Etch Primer is a high performance primer providing superior adhesion and outstanding protection to a wide range of metal surfaces. Its ready-for-use formulation is perfect for brush application and ideal where rapid topcoating is required.
Touch Dry
15 minutes
Re-coat
15 minutes
Cleaning materials
Acetone or Dulux Urethane Thinner
Application Tools
Brush, Roller, Spray
This is an industrial product designed for use by experienced Protective Coatings applicators. Where conditions may require variation from the recommendations on this Product Data Sheet contact your nearest Dulux??representative for advice prior to painting. Do not apply in conditions outside the parameters stated in this document without the express written consent of Dulux??Australia. Do not apply at temperatures below 5°C. Do not apply at relative humidity above 85% or when the surface is less than 3°C above the dewpoint. Do not apply over scale bearing steel. Abrasive blast cleaned surfaces must be primed within 4 hours. Excessive dry film thickness should be avoided as this may result in delamination.
Ensure the surface has thoroughly dried prior to application. Do not apply on top of existing painted surfaces. Commercial applications may require additional surface preparation. Aged/lightly rusted surfaces: Remove any rust by scraping, sanding or wire brushing. Wipe surface with acetone to remove any residual grease, oils and dirt. Bare steel and wrought iron: Wipe surface with acetone to remove any residual grease, oils and dirt. Galvanised iron, ZINCALUME®, aluminium, copper, brass and stainless steel: Clean surface with Selleys® Sugar Soap and a Scotch-Brite® Pad to remove any grease, oils and dirt. Rinse with clean water.
Stir contents thoroughly with a broad flat stirrer using a stirring, lifting action. No thinning is required for brush or roller application. For spraying thin up to 150ml per litre with acetone or Dulux Urethane Thinner. Stir well prior to applying one coat of Dulux Metalshield® RFU Etch Primer by brush, roller or spray. For best results, apply the primer immediately after the surface preparation is complete. Application and drying temperatures must be above 10°C.
