Porter’s Stone Paint Fine has a lightly textured, fine stone-like finish that provides outstanding performance with the appearance of softness that comes with completely flat paints. Superior coverage, low VOC, low odour, and an ultra-flat sheen level that hides surface imperfections and delivers perfect colour.
Touch Dry
1 hour ( at 25 Deg C and 50% elative Humidity)
Cleaning materials
Water
Application Tools
Brush, Roller, Other
Do not apply in high humidity, below 10°c or above 30°c.
Check colour before use.
Provided the surface is clean and sound, Porter’s Stone Paint is self-priming and can be applied directly over previously painted surfaces. (Except oil-based paints or polyurethanes). High gloss paints or varnishes should be sanded to remove gloss and create a “keyed” surface.
Surfaces painted with oil-based paints, or previously painted surfaces with loose, peeling or flaking paint must be made sound by scraping off loose paint. Fill nail holes and cracks with suitable filler, sand and dust off. Spot prime all joints and repaired areas with Porter’s Prepare & Prime, then apply one coat to entire area.
Substrate should be a clean well-held surface free from loose material, dirt, grease, oil and mould. Dust down before proceeding.
On new unpainted plasterboard sheeting, render, brick or timber, spot prime all joints and repaired areas with Porter's Prepare & Prime, then apply two coats of same to entire area.
On new unpainted fresh set plaster do not proceed until plaster has thoroughly set and has dried completely. Firstly, apply 1 coat Porter’s Mineral Silicate Primer by brush or roller. Touch dry 20 minutes. Allow 2 hours dry time. Then apply by brush, roller or spray 1 coat Porter’s Prepare & Prime.
Do not apply paint if Relative Humidity is above 85% or temperature is within 3°C of Dew Point.
Do not apply if the surface temperature is greater than 30°C or below 10°C, or likely to fall below 10°C during the application or drying period.
Stir thoroughly prior to use. Apply two coats by brush, or for Stone Paint Fine only, a medium nap roller. For a natural cement-like appearance apply by lime wash brush in a multidirectional manner. Touch dry in 1 hour. Allow minimum 2 hours dry time between coats. Allow 6 hours dry time.
