Dulux Professional® Exterior is 100% acrylic Gloss with excellent application and opacity. It is suitable for use on exterior surfaces such as masonry, cement render, brick, fibro cement, suitably primed timber and metal (except roofing).
Touch Dry
30 minutes
Cleaning materials
Water
Application Tools
Roller, Brush, Spray
All preparation and painting must conform to AS2311: The Painting of Buildings.
Do not apply to roofs or surfaces used for the collection of drinking water. Do not paint at temperatures below 10C or when the temperature of surface may fall below 10C during the drying period.
Check the adhesion of old paint by cutting an 'X' through the film with a razor blade or trimming knife, press cellulose tape firmly across the cut and rip it off. If the old paint comes off with the tape it should be removed before repainting.
Occasionally when dew or condensation forms on the newly dried film, a slight milky deposit will be observed on the film. This is quite normal and does not result in reduced performance simply hose or wipe it with a damp rag and it will not reappear.
All surfaces must be thoroughly cleaned and free of all dirt, dust, grease, loose or flaking paint. Efflorescence or mould on masonry or concrete surfaces must be treated, then apply primer, sealer or undercoat as required.
Brush, roller, conventional or airless spray
Stir contents thoroughly before and during use with a broad flat stirrer, using an upward lifting action.
Brush/Roller
Rinse brush or roller in water before starting and use while still slightly damp. Apply two full even coats direct from the container. Under hot or windy conditions or on very absorbent surfaces, up to 100 ml clean water may be added per litre to assist application. Use a short nap roller. Avoid excessive brushing or rolling back into paint which has been drying some minutes.
Airless/Conventional Spray
Suitable for application by all standard spray equipment. If necessary thin with up to 100 ml per litre of water to aid atomisation.
