Dulux Concrete & Paving Sealed Surface Primer is the second stage in preparing the surface for the finishing coat. It is formulated for use over any existing coating to reinforce the surface for optimal adhesion of subsequent coats of paint.
Re-coat
Min 2hrs. Max 2hrs
Cleaning materials
2 hours
Application Tools
Air Spray, Brush, Roller
1. Stir thoroughly before and during use.
2. Add all Part B material, found in the tube under the cap, into the can and mix thoroughly with a flat stirrer for 1-2 minutes.
3. Mask all adjacent surfaces not needed for the application.
4. Use a brush to apply to any edges and hard-to-reach places.
5. Use a roller to apply 1 coat evenly across the surface.
6. Gently go over the surface in the same direction with an unloaded roller using minimal pressure to give a smooth consistent finish.
7. Allow the coated surface to dry.
Do not pour leftover paint down the drain.
Unwanted paint should be brushed out on newspaper and allowed to dry, and then disposed of via domestic waste collections.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz
Leave empty paint containers open in a well-ventilated area to dry out. When dry, recycle the container via steel can recycling programs.
Disposal of empty paint containers via domestic recycling programs may differ between local authorities. Check with your local council first.
Do not reuse container unless thoroughly decontaminated.
For more information on responsible disposal of paint and packaging visit paintback.com.au or painttakeback.co.nz
