Dulux Professional® FASTFINISH™ Water Based Enamels are premium acrylic products suitable for use on interior and exterior doors, window frames and trim. They are a great alternative to traditional oil-based enamels with the benefits of using an acrylic paint.
Cleaning materials
Water
Application Tools
Spray
All preparation and painting must conform to AS2311: The Painting of Buildings. Do not use at temperatures below 10C, or when the temperature of surface may fall below 10C during the drying period. Avoid exposure to steam and condensation for 48 hours after application. Although the film is dry to touch in 30 minutes allow 7 days for film to fully cure before washing. Tinted Colours: Ensure that the paint is thoroughly shaken and stirred immediately after addition of tinter to the can and again before use.
Previously painted surfaces (except cement sheet) must be sanded to remove all loose, powdery and flaking paint. Wash down with sugar soap and rinse with clean water to remove any dirt, oil or grease. Treat any mould present on the surface with a bleach solution diluted 3 to 1 with water, then wash again with fresh water. Sand all gloss & semi-gloss surfaces to a dull finish. Fill any cracks or holes with a suitable filler, sand and dust off. Bare plasterboard or timber should be prepared by applying a suitable undercoat or primer.
Brush, roller and spray
Stir well before use with a wide (approx 25mm) flat stirrer in a circular, lifting motion. Apply two coats by brush,roller or spray allowing at least two hours drying time between coats.
Airless Spray Advice
Tip size: 0.009&ndash ; 0.011"
Pressure: 1300&ndash ; 1700psi
Air-Assisted Airless spray advice
Tip size: 0.009– 0.011"
Pressure: 900– 1100psi
